Rendering and electrics

Well this week has been a busy week if you have read the story before this one about my cooking. Well i have been busy in the kitchen. After the electrician came to see what i wanted doing. i explained that it was just the kitchen at the point. It's no point doing the whole house as i am not sure what and where things will be going. I got started after the electrician left by putting wires into the pipes in the wall so i could pull the cables through ready for when the wall panels are up. If i waited for the panels to be put up and then found a problem getting the cable through the pipes i would be in trouble. So the cable for the sockets is now in place. All my wiring is being run from the cellar as this will make things easy should any changes be needed at a future date. From the cellar it is easy to get to the main supply. Sadly i do not have the skills to complete the wiring as for safety it must be done by a qualified electrician.

The bottom photo shows the cable through the wall ready for the electrician. I have marked on the photo the cable through the wall. You will also note that i have just mopped the floor. It may seem silly in what is a building site but i need to mop the floor often to keep the dust down. Yes a man can wash and clean i am no different than anybody else if it's not done by me it doesn't get done.

After taking the ceiling down the wall above the door that will go to the veranda and the opposite wall needed to be rendered ready for the insulated wall panels to be fitted. As the photos show i have rendered the walls ready for the panels so this week i hope to be going for the panels i am lucky that i kept my trailer as the plaster board sheets will fit in perfectly. One internal wall will just be plaster boarded the others will have insulation on the back. The biggest problem i have is that of dust. I keep the doors shut but all the time i find that there is dust everywhere. Anybody would think that i don't keep the place clean but i do.